Q. Can I put any wallpaper stripping additives in my unit?
A. Although some of these additives are designed for wallpaper strippers
they are not recommended for ours, as they can damage internal
components.
Q. How do I remove stubborn paper?
A. Score the paper either with a knife or perforating tool
then use steamer as normal.
Q. Can't I just hold the plate on for longer?
A. Do not hold it in the same spot for more than 10 seconds, as there is a
risk it will burst the plaster underneath.
Q. How close can I get to light switches with the plate?
A. Do not allow water or steam to enter light switches or power points.
Isolate the power at the main fuse box and then remove the face
plate. This will allow you to remove any old paper that is stuck behind
the socket/switch by hand with a damp sponge. Replace face plate
when finished.
Q. Is it safe to remove Artex?
A. Normally Artex can be removed using the same method for wallpaper
although the steam time will be longer. CAUTION: Some textured
finishes may contain asbestos which may be hazardous to health and
which are subject to licensing controls operated by the HSE (Health
and Safety Executive).
Q. How about ceilings?
A. Always wear appropriate PPE (Personal Protection Equipment) when
using any Earlex appliance. We recommend that you will need eye
and hand protection due to possible hot water discharge from
condensing steam.
Never paper over old wallpaper.
For faster removal move the steamplate slowly along the paper and
follow with scraper.
Use Earlex Steam cleaning accessories to get the best from your
Wallpaper Stripper.
Always wear suitable propective clothing when decorating.
Pre-score wallpaper/vinyl to allow the steam to penetrate using a
perforator tool.
To speed up the process of heating the water in the boiler unit add
freshly boiled water.